I LEARN DMA...=)

Bismillah...


Segala puji bagi Allah atas segala nikmatNya yang tidak terhingga..Hamba bersyukur Ya Allah kerana masih lagi diberikan kudrat untuk meneruskan kehidupan sebagai seorang hamba..


Subhanallah, today I have so many works to do..Starting from daily checkup maintenance as usual, I have to change three "tong" gas that very heavy...continued with measuring the width and thickness of 18 samples using micrometer..that one not take time..I finished measuring before lunch...
Hari ni lunch K.Wani bawak pi makan kat Restoran Nasi Kandar Pelita..area situ jugak..boleh tahan la lauk kat situ..not bad but quite spicy...=p


Then, after lunch.. Miss Pang asked me to cut samples of PSR...110 for MD and 110 for TD...
That's mean the total pieces are 220...Aduh..banyaknya..
I think I can finish it today but not enough time because Miss Pang wanted to teach me how to operate DMA (Dynamic Mechanical Analysis)...I'm very excited to learn this..=)


Bukannya susah nakk operate DMA nih...mcm K.Wani cakap,staff kat sini tahu handle instrument sebab diorang dah selalu buat...so never give to learn and try again...ok
Mula-mula tu agak susah la sebab nak ingat step by step how to operate that DMA..need to setting,adjust and wait..the difficult part is to adjust the sample correctly in centre...hmm...memang menguji kesabaran...
if the graph show the blue circle out of the limits, then I need to open back the sample and adjust again..
every sample need to be run 1 hour 30 min...I need to run 18 samples..Oh my God..until next week it can be finished...nevermind..=)..its better I have work to do rather than sitting in the office ( get bored)..
So,2 sample dah settle...There are 16 more to go...Ya Allah, give me strength to work..ikhlaskan hati hamba dalam setiap pekerjaan yang hamba lakukan..Amin